Apply to the surface of the model where you will be sliding the decal off the paper backing. Use a soft flat artist's brush and apply Micro Set where you are going to apply the decal. Then slide the decal off the backing paper using a small pointed tip synthetic bristle brush to carefully position the decal in its proper position. Blot the decal carefully with a tissue or paper toweling, being careful not to disturb its position. Allow the decal to dry overnight. It will then be ready for a protective coat of Micro Coat Flat, Satin or Gloss.
Softens the decal itself allowing it to drape down onto the surface of the model, comforming perfectly to surface irregularities without distortion. Apply with as few strokes as possible so as not to disturb the decal. Then allow the decal to dry without disturbing it.
Similar to the flat finish option but this creates a satin finish. Make sure the model is completely dry from any previous applications. Mask the areas you do not wish to cover and either apply with a soft brush or airbrush. If applying with an airbrush, you may need to thin the product- do so only with water.