SINGLETS

Micro Singlet Servo Decoder

The singlet has a baby brother, the Micro Singlet. It is a simple servo decoder designed to drive turnouts and only turnouts. It solves the problem of servo buzzing by turning the servo off at the end of the throw. Special circuitry and programming has been built in to accomplish this without a large jerk at restart.

Micro Singlet - designed to control turnouts with DCC or a pushbutton. Simpler than the classic Singlet it is designed only for turnouts.

No buzzing! - servo turns off at end of throw

Simpler setup - center the servo and mount - no alignment needed

Switch with DCC or the included fascia controller

Miniature Servo Motor (SG90)

Have plenty of power for hinged point turnouts and smaller rail (c55 and smaller) solid point turnouts - when used with the servo mounting kit (SMK002 below) then it can handle higher loads, up to c100 non-hinged rail.  If the point rails are hinged then the rail size is not an issue - it has been used up to G scale. Our servo brackets are custom made to fit these servos. Size 1.25" wide (including mounting tabs) x 0.5" deep x 1.125" tall.  Servo lead about 7".  The label on the servo and the lead colors may vary between batches.  Works with all of our boards.

Note: The current demand from the decoders are 0.1 amps. On a DCC layout the addition of a additional booster for a large number will require the additional booster.

Micro Servo Bracket Kit (servo not included)

3D Printed Bracket for Mounting a Micro Servo under the Layout for turnout control. 

Switch Wright Servo bracket, provides a Centre-Over Spring to Securely Hold Points.