HARDWARE

PLCC Extractor

Circuit Board Extractor, avoids bending the socket pins & damage through electrostatic discharge. 

NCE spares

Replacement 2 & 4 pin plugs for the NCE Systems.

NCE

Dual Relay connects to a Switch-it or Switch 8 decoder to provide two SPST or one DPDT relay output for switch up to 2 amps of power.

Typical uses:

Control polarity of dead frogs 
Automatic reverse loop control 
Turn staging yard tracks on on/off 
Provide isolated turnout position information to signaling ;
Computer control using AIU-01

Note: The markings for Positive [+] and negative [-] are reversed as is the markings for the normally open [n.o.] and normally closed [n.c.] .

This is a factory error in the printing and has no effect on the operation.

WFD-30 NCE CAB Bus Wi-Fi Interface

Provides Wi-Fi control of DCC locomotives and accessories using your NCE Command Station from a hand-held such as a phone, tablet or dedicated throttle that uses the Wi Throttle protocol. WifiTrax has thoroughly tested operations using the popular and excellent apps Engine Driver for Android and WiThrottle for Apple.
If you want a more tactile driving experience, use the popular TCS UWT-100 Universal Wi-Fi Throttle. 
Please contact WifiTrax support for any questions or issues relating to operation with 3rd-party apps rather than the authors of these apps.

WFD-31 NCE CAB Bus Wi-Fi Interface

PCP/UTP WiFi Interface

Fascia Not Supplied

NCE

Black Plastic Fascia Cover For WFD-31, PCP & UTP

Black Metal Fascia Cover available.

NCE

Add this USB computer interface for computer programming and/or operation of your Power Cab equipped layout. Requires USB cable, computer and railroad computer program such as JMRI Decoder Pro and Panel Pro.

NCE

Use one button to control multiple switches or macros on your NCE DCC system. You can have up to 30 pushbuttons, toggle switches, block detectors,etc. Can be connected for control of turnouts, signals and other devices. Easy programming, just plug in a Pro Cab. Simple hook up, one Cab Bus connection and 2 wires for each pushbutton or other input device. Can be used to perform simple automatic train control and other layout automation tasks.

NCE

Add a separate PCP panel to operate your Power Cab in other places or on other layouts. Use with the MRRC TX-01

NCE

All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab bus power when bus lengths exceed 20 meter [60 feet]. Shown with the included fascia plate.

NCE

The operator side is fitted with RJ-12 jacks for throttles while offering CAT5 cable connections for improved noise rejection on larger layouts using standard computer CAT 5 cables. This board also provides a convenient point to add additional 12 Volt cab bus power when bus lengths exceed 20 meter [60 feet]. Shown with the included fascia plate.

NCE

Auto-SW is a smart relay board with one input (two wires from powercab output) and two outputs. One output for the main layout and a second output for a programming track.It senses when you put the PC into program track mode and energizes a relay that disconnects layout track power and connects a dedicated program track.  

Designed to detect packets on the DCC track bus that initialize service mode programming aka- programming track mode. When it sees those packets it throws a relay disabling one set of outputs and activating the other.

It does not operate when using PROGRAM ON MAIN.

It is designed to be used with the Powercab in the original starter set configuration only.