EB1, CP6, AR10, SNUBBERS, RELAYS

Reduces or eliminates voltage spikes on long runs of DCC bus wire,this is especially important on any DCC track bus wire 40 feet [12 meters] or longer. 

Protects decoders from damaging inductive voltage spikes while help preveting temporary loss of control or runaway problems by preserving DCC waveform accuracy.

WHAT ARE THE SIGNS YOU MAY NEED A RC FILTER ON THE TRACK BUS?

1) Loss of train control

2) Runaway engines (Take off) :

3) Loss of decoder programming. 

4) Decoders blowing up.

Consider installing a snubber at the end of each cab bus

NCE

No Halt Insurance - 1.25" x 0.640" x 0.290"

Eliminates or reduces the following due to Dirty Track

Stalling, Sound Interruption & Light Flicker

Caution Do not exceed DCC track Voltage of 15V

NCE

Provides short circuit protection for one power district. Can be used with most DCC systems.

This is recommended for use with the Power Cab as a primary means of protection with the EB1 set to 1.5 amps for a distributed protection add a CP6.

NCE

CP6 Circuit Protector

Provides circuit protection for up to six sections of your railroad. Operates with any DCC system. Each globe allows 1 amp per section and sections can be connected together for more power per section.

NCE

Dual Relay connects to a Switch-it or Switch 8 decoder to provide two SPST or one DPDT relay output for switch up to 2 amps of power.

Typical uses:

Control polarity of dead frogs 
Automatic reverse loop control 
Turn staging yard tracks on on/off 
Provide isolated turnout position information to signaling ;
Computer control using AIU-01

Note: The markings for Positive [+] and negative [-] are reversed as is the markings for the normally open [n.o.] and normally closed [n.c.] .

This is a factory error in the printing and has no effect on the operation.