OCTOPUS III
-
PLCC Extractor
Circuit Board Extractor, avoids bending the socket pins & damage through electrostatic discharge.
*
A$16.00 -
Octopus III
Board has 8 positions for driving servos between two positions and 8 inputs for fascia controllers or toggle switches.
Octopus III uses the remote board (below) to align the servos and has automated endpoint adjustment as well as full manual control.
Ideal for use with TAM miniature servos and the servo mounting kit Power with 5-24V DC (do not use AC).
Octopus III has a built-in switching power supply for high efficiency and greater range.
Board is 2.5" x 1.9"
*
A$79.00 -
Octocoder - Stationary DCC decoder Add-on for Octopus II/III
You can control your Octopus II or III with the Octocoder, a simple stationary DCC decoder.The board provides connections os you can also connect fascia controllers and LEDs for local control. (Will not work with toggle switches however.)No CVs to program - just put on the address junper and issue a turnout command from your throttle to set the address block.Uses 8 consecutive DCC addresses.*
A$34.00 -
Remote Aligner for Octopus III
Used with the Octopus III to align of servos (cannot be used with the Octopus II).
Just one of these needed for all of your Octopus IIIs.
Suppied with a 7' cable for ease of installation.
Board is 2.7" x 1.7" in size
*
A$25.00
