QUAD PIC

PLCC Extractor

Circuit Board Extractor, avoids bending the socket pins & damage through electrostatic discharge. 

Quad Relay Daughter Board

Add this board to the Quad-Pic by plugging it into the expansion port and you have 4 ports for plugging in the remote relay board above.

Remote DPDT Relay Board

This remote relay plugs into the breakout daughterboard and gives you two circuits for powering frogs, signals and so forth.  Board has a 12V, 1A hi-sensitivity relay that draws just 13 mA, relay drive circuitry, and a terminal block for easy wiring.  Can also be used without the Quad - red wire, 12V, black wire, ground, white wire, signal (0V = OFF, greater than 1.4V is ON).  Comes with a 12" extension cable - extra length can be added with servo extensions.

Does not work with a Micro Singlet, for Singlet 11 only.

TAM Valley

DPDT relay for using on a Y cable in conjunction with a fascia controller. (Will work without the fascia controller.) 

A 6-pin connector block to simplify wiring. High-sensitivity coil requires 30 mA. Contacts are rated 1 Amp at 24VDC.

Can also be used without the Octopus - red wire, 5V, black wire, ground, white wire, signal (0V = OFF, greater than 1.4V is ON).] 

Note:- Y Cable has to be purchased separately.