DCC CONTROL

DPDT relay for using on a Y cable in conjunction with a fascia controller. (Will work without the fascia controller.) 

A 6-pin connector block to simplify wiring. 

High-sensitivity coil requires 30 mA. 

Contacts are rated 1 Amp at 24VDC.

Can also be used without the Octopus - red wire, 5V, black wire, ground, white wire, signal (0V = OFF, greater than 1.4V is ON).] 

Note:- Y Cable has to be purchased separately.

NCE

Motor rating 1.3 Amp continuous, 2 Amp peak stall, with stay alive. All four function outputs have lighting effects generators and a nine pin JST wiring harness with an NRMA 8pin plug which provides easy installation. Size: 1.50" x 0.63" x 0.25" decoder - 1.12'' x 0.63'' x 0.19'' stay alive.

Caution: Not for use with more than 15volts track voltage.

NCE

All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab bus power when bus lengths exceed 20 meter [60 feet]. Shown with the included fascia plate.

Power Drop Wire

Simply crimp a NCE Quick Connect & push onto a NCE bus tap

No soldering required

NCE 

#524 0156 - 16MTC 6 function decoder with 21 pin 'MTC' plug.Silent Running torque compensated motor drive Torque Compensation for ultra smooth low speed performance Motor rating 3/4 Amp continuous, 1.2 Amp stall All four function outputs have lighting effects generators

NCE

The operator side is fitted with RJ-12 jacks for throttles while offering CAT5 cable connections for improved noise rejection on larger layouts using standard computer CAT 5 cables. This board also provides a convenient point to add additional 12 Volt cab bus power when bus lengths exceed 20 meter [60 feet]. Shown with the included fascia plate.

Power Drop Wire

Simply crimp a NCE Quick Connect & push onto a NCE bus tap

No soldering required

NCE

Auto-SW is a smart relay board with one input (two wires from powercab output) and two outputs. One output for the main layout and a second output for a programming track.It senses when you put the PC into program track mode and energizes a relay that disconnects layout track power and connects a dedicated program track.  

Designed to detect packets on the DCC track bus that initialize service mode programming aka- programming track mode. When it sees those packets it throws a relay disabling one set of outputs and activating the other.

It does not operate when using PROGRAM ON MAIN.

It is designed to be used with the Powercab in the original starter set configuration only. 

Power Drop Wire

Simply crimp a NCE Quick Connect & push onto a NCE bus tap

No soldering required

Power Drop Wire

Simply crimp a NCE Quick Connect & push onto a NCE bus tap

No soldering required