Liquids

  1. MicroSet 1 fl. oz. [1]

    MicroSet 1 fl. oz. [1]

    Micro Set should be applied to the surface of the model where you will be sliding the decal off the paper backing. To apply Micro Set: Use a soft flat artist's brush and apply Micro Set where you are going to apply the decal. Then slide the decal off the backing paper using a small pointed tip synthetic bristle brush to carefully position the decal in its proper position. Blot the decal carefully with a tissue or paper toweling, being careful not to disturb its position. Allow the decal to dry overnight. It will then be ready for a protective coat of Micro Coat Flat, Satin or Gloss.

    1 fl. oz. [1]
    A$7.95

  2. Micro Sol 1 fl. oz. [1]

    Micro Sol 1 fl. oz. [1]

    Micro Sol completely softens the decal itself allowing it to drape down onto the surface of the model, comforming perfectly to surface irregularities without distortion. Apply Micro Sol with a small flat brush. Apply with as few strokes as possible so a not to disturb the decal. Then allow the decal to dry without disturbing it. One application is enough in most cases, but if necessary, a second application of Micro Sol can be helpful.

    1 fl. oz. [1]
    A$7.95

  3. Micro Flat 1 fl. oz. [1]

    Micro Flat 1 fl. oz. [1]

    Micro Flat allows the user to create a flat finish on the model after painting and decalling has occurred. To use, apply your decals using the Micro Sol or Micro Set products. Mask the areas which you do not wish to cover with the Micro Flat and then apply with either a brush or an airbrush. If airbrushing, thin the Micro Flat with either Alcohol or Water.

    1 fl. oz. [1]
    A$7.95

  4. Micro Satin 1 fl. oz. [1]

    Micro Satin 1 fl. oz. [1]

    Micro Satin is similar to the flat finish option but this creates a satin finish. To apply, make sure the model is completely dry from any previous applications. Mask the areas you do not wish to cover and either apply with a soft brush or airbrush. If applying with an airbrush, you may need to thin the product- do so only with water.

    1 fl. oz. [1]
    A$7.95

  5. Micro Liquitape 1 fl. oz. [1]

    Micro Liquitape 1 fl. oz. [1]

    Micro Liquitape is designed for the modeller who is a little unsure about the particular placement of certain items. Liquitape is a tacky adhesive that is for temporary joining of most modelling materials, especially if you need to remove and replace it with ease.

    To apply, place onto the desired surface and allow the Liquitape to dry- it will change colour. Then apply to the surface you wish.

    1 fl. oz. [1]
    A$6.00

  6. Micro Metal Foil Adhesive 1 fl. oz. [1]

    Micro Metal Foil Adhesive 1 fl. oz. [1]

    Micro Metal Foil Adhesive is perfect for any modeller wishing to create a realistic metal surface on their models.

    To apply, coat the back of a piece of pre-cut foil with the adhesive and wait for it dry, afterwards apply it to the item. Using a cotton bud, lightly burnish the foil onto the item.

    1 fl. oz. [1]
    A$6.00